Napco MA850 Style Keypad

---

 TO DISARM:
Enter your code at keypad. If error is made, you must wait 5 seconds before re-entering.

TO ARM:
Close all protected doors and windows, even the door near the keypad. Wait for solid green light & then enter your code. Wait for red armed light & then exit (30 seconds).

TO FIND OPEN ZONE:
Green light will be flashing. Push (3) and hold down until it beeps (about 5 seconds). Open zone will show in display. If unable to clear zone, see to bypass below.
 

TO BYPASS OR SHUNT:
Press (S) plus zone # you wish to bypass. The yellow light will come on. Enter code, red and yellow light will be on.

RESET SMOKE/FIRE:
Enter code twice to silence. Determine what caused alarm, vent smoke by opening windows, doors, etc., when clear, push (9) and hold until it beeps. Red fire light on keypad should shut off within 60 seconds.
* If fire reset fails second time call service*

TO CHANGE CODE:
Press (8) and hold until it beeps. Enter program code (usually 5-4-3-2-1), then push (S), then the user # (1,2,3,OR 4), then enter new 4 digit code. Repeat for up to 4 users. When done enter (S)(S).

DISPLAY SHUNT:
Push (2) and hold until it beeps. Zones that have been shunted will show in the display.

DISPLAY OPEN ZONE:
Push (3) and hold until it beeps. Zones that are open will show in the display.

INSTANT PROTECTION:
Push (4) and hold until it beeps. This will cancel the entry delay. Only for use while at home.DISABLE
 

REMOVE / UNDO BYPASS:
Arm the system, then disarm it. This should cancel any shunted zones.

TEST BATTERY/SIREN:
Push (1) and hold until it beeps. The siren should sound for 5 seconds & then shut off. Central station will not be notified. This test checks power, battery & siren.